Hello Guest it is September 28, 2020, 09:18:21 AM

Author Topic: Is there an easy method?  (Read 1232 times)

0 Members and 1 Guest are viewing this topic.

Is there an easy method?
« on: November 05, 2012, 12:13:59 PM »
I am trying to put a .5" radius on a piece of wood to make a jig for clamping an upcoming job to.  Basically, I will be receiving pre-pressed plies that have a concave that runs through out the whole piece, which is constant the whole length, and is a .5" radius.  My plan for the jig is to take this sub-flooring that has been pressed and glued, and round the edges off, making a .5" radial convex (leave the center high and take the edges down).  I own Aspire, but can't figure out an easy method to achieve this like in SolidWorks.  I wasn't sure if there was a wizard somewhere, that was capable of this from within Mach3