Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: SlikChit on November 05, 2012, 12:13:59 PM
-
I am trying to put a .5" radius on a piece of wood to make a jig for clamping an upcoming job to. Basically, I will be receiving pre-pressed plies that have a concave that runs through out the whole piece, which is constant the whole length, and is a .5" radius. My plan for the jig is to take this sub-flooring that has been pressed and glued, and round the edges off, making a .5" radial convex (leave the center high and take the edges down). I own Aspire, but can't figure out an easy method to achieve this like in SolidWorks. I wasn't sure if there was a wizard somewhere, that was capable of this from within Mach3