HUM something fishy.

Go to COnfig / native units / what is selected mm or inch?

Go to COnfig/motor tuning what is the Steps per setting on X axis(lower left side of window?

On the main screen to the right of the DROs is there a yellow led blinking ?

Main screen top right DO you see a G20 in the Modal line or a g21?



(;-) TP

MM is selected

Steps per in the motor tuning is 200

No LED flashing

And Yes there is a G20 in the #s  at the to right


Thanks for your help man, I really appreciate it:)

Oh sorry, its a G21 not a G20 at the top right

WHen you commanded the machine to move 10mm and it moved 10.5" what did the DROs say it moved ?

(;-) TP

HAve you found the problem yet?

(;-) TP

Something must have reset when I tuned my computer off.  Your code does now move the machine 10MM:)  But my tool-path is still massive.  Is there anything else it could be?

Do you think its the Code?  I have a mach3 MM post-processor so it seems like the code should be right.  Ive run the code offline and everything seems great, It's just way bigger than its supposed to be.

Yeeeeeehaaaa!! Awesome, it just dawned on me that I forgot to redo my limits after I calibrated, now all is good.  The code wasn't to big, the table was to small.  I'm a total dunce.  Thanks for your help though man.

Glad you got it figured out

(;-) TP