Hello Guest it is May 20, 2019, 01:02:31 PM

Author Topic: Spindle start  (Read 1337 times)

0 Members and 1 Guest are viewing this topic.

Spindle start
« on: October 20, 2012, 05:13:37 PM »
Is there a way to have mach pause for say 5 seconds for the spindle to start before it moves to its first cut location? I'm finding its plunging down before the spindle is up to speed.

Offline Hood

*
  •  25,811 25,811
  • Carnoustie, Scotland
    • View Profile
Re: Spindle start
« Reply #1 on: October 20, 2012, 05:17:34 PM »
Set a delay for spin up and spin down, its on Spindle setup page, from Ports and Pins.
Hood
« Last Edit: October 20, 2012, 05:19:05 PM by Hood »
Re: Spindle start
« Reply #2 on: October 20, 2012, 05:35:39 PM »
Thanks  ;)