Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: vtx1029 on October 20, 2012, 05:13:37 PM

Title: Spindle start
Post by: vtx1029 on October 20, 2012, 05:13:37 PM

Is there a way to have mach pause for say 5 seconds for the spindle to start before it moves to its first cut location? I'm finding its plunging down before the spindle is up to speed.

Title: Re: Spindle start
Post by: Hood on October 20, 2012, 05:17:34 PM

Set a delay for spin up and spin down, its on Spindle setup page, from Ports and Pins.
Hood

Title: Re: Spindle start
Post by: vtx1029 on October 20, 2012, 05:35:39 PM

Thanks  ;)