Hello Guest it is March 28, 2024, 07:46:45 AM

Author Topic: inputs  (Read 3597 times)

0 Members and 1 Guest are viewing this topic.

Offline Bill_O

*
  •  562 562
    • View Profile
inputs
« on: October 19, 2012, 04:36:04 PM »
I am just getting started setting up my CSMIO IP-M
With only a switch to do some testing i am not getting it to be seen by mach or the Modules Diagnostic inputs.
I can see it turn on and off on the Digital IO and on the module itself.

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: inputs
« Reply #1 on: October 19, 2012, 05:39:14 PM »
Have you got Mach set to the correct port and pin? I have the bigger version and that would be port 10 pin 0 in it so I assume the same in your M controller.
Hood

Offline Bill_O

*
  •  562 562
    • View Profile
Re: inputs
« Reply #2 on: October 22, 2012, 09:17:42 AM »
Hood,
I had port 10 but pin 1.
It is working now.
Thanks,
Bill