I have a problem on the lathe and I was wondering if anyone has seen the same thing?
Everything is normal until after I have run one job, then the DRO's change normally but the X and Z stepper motors do not move, until Mach3 is restarted, at which time all is normal again until I run a job and the issue reoccurs.
This is a new problem, which has persisted for a few days so I suspect it is something I have done, but for the life of me, I do not know what.
I don't have to restart the PC, just Mach3.
My hardware is as follows:
PC P4
ESS
BOBs etc.
Thanks in anticipation
Dave