Chad
Eagle you can design the circuit
You get Gerber,Excellon,HPGL
or Routing,Drilling,Label Mask, Trace mask
The Wizard would take this format
and convert it to a usable format for Mach3
So you can Drill all holes
Route all traces
Then with the inkjet print head from Parrallex
Print your Component labels,
And your Trace Mask
Making Mach3 the Swiss Army knife of the DIY Tool industry
Besides i have tried the photo etch way of making Boards
and they usually turn out bad OK enough for personal use
embarrassing for commercial work
Maybe you can post some pics of your boards i would not post any of my boards
and hand drilling sucks no mater how good your board is