Hello Guest it is December 08, 2021, 01:14:55 PM

Author Topic: Mach3 Default Screen  (Read 2443 times)

0 Members and 1 Guest are viewing this topic.

Mach3 Default Screen
« on: September 18, 2012, 03:31:53 AM »
Hi All

My question is relative simple. When i launch mach3 mill, i get a screen with the Spindle block at the far right hand side.
When i launch mach3 laser, i get a screen with a Fixture block at the far right hand side.

Screenshots attatched and area circled.

I dont have much use for the fixture block, and would like to replace it with the spindle block.
Where/how do i do this ?

Thanx
Andre

Offline Hood

*
  •  25,838 25,838
  • Carnoustie, Scotland
    • View Profile
Re: Mach3 Default Screen
« Reply #1 on: September 18, 2012, 03:34:43 AM »
View menu then Load Screen. It is the Plasma screen rather than laser, so load the plasma.set.
Hood
Re: Mach3 Default Screen
« Reply #2 on: September 18, 2012, 03:40:18 AM »
I knew i would take 10 seconds to fix :-)

Thanx Hood

Andre