Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Andre007 on September 18, 2012, 03:31:53 AM
-
Hi All
My question is relative simple. When i launch mach3 mill, i get a screen with the Spindle block at the far right hand side.
When i launch mach3 laser, i get a screen with a Fixture block at the far right hand side.
Screenshots attatched and area circled.
I dont have much use for the fixture block, and would like to replace it with the spindle block.
Where/how do i do this ?
Thanx
Andre
-
View menu then Load Screen. It is the Plasma screen rather than laser, so load the plasma.set.
Hood
-
I knew i would take 10 seconds to fix :-)
Thanx Hood
Andre