Hello Guest it is October 15, 2021, 06:52:34 PM

Author Topic: Manual Calibrate Spindel  (Read 1503 times)

0 Members and 1 Guest are viewing this topic.

Manual Calibrate Spindel
« on: September 17, 2012, 12:47:55 PM »
Is it possible to calibrate spindle in manual mode?
-Set  S(rpm)
-Measure voltage at the output of the converter then the PWM to 0-10V
-RPM value  =Output voltage * 40Hz(For spindel  24000rpm max) * 60
-Wrote down the value in the table. Click Next Measure.

It can accurately calibrate the output voltage is controlled by the spindle speed.

–°an be such already in mach3?

Best regards, Sergey
« Last Edit: September 17, 2012, 12:54:25 PM by cncstep »