Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: cncstep on September 17, 2012, 12:47:55 PM

Title: Manual Calibrate Spindel
Post by: cncstep on September 17, 2012, 12:47:55 PM
Is it possible to calibrate spindle in manual mode?
-Set  S(rpm)
-Measure voltage at the output of the converter then the PWM to 0-10V
-RPM value  =Output voltage * 40Hz(For spindel  24000rpm max) * 60
-Wrote down the value in the table. Click Next Measure.

It can accurately calibrate the output voltage is controlled by the spindle speed.

–°an be such already in mach3?

Best regards, Sergey