A while back I had it all done BUT it may have been purged in a clean up (;-(.
It also did cross over grinding each pass of a lobe pair crossed over to another pair. It was very intense.
A full size Chevy V8 cam required about a million lines o fG code to be loaded. But being sub programmed it required little code being written. The V8 cam would take about 30 seconds just to calculate and load to screen.
The hard part was getting SheetCam to post the lobe pairing correctly. Les came through with a lot of help on that one.
AN added point was it could also do CRANK Grinding as well as CAM grinding.
NOW to find the container files for it all (;-(.
(;-) TP