Hello Guest it is September 21, 2019, 12:10:15 PM

Author Topic: need help with c10 board and mach 3  (Read 1900 times)

0 Members and 1 Guest are viewing this topic.

need help with c10 board and mach 3
« on: May 27, 2012, 08:10:15 PM »
I am working on a new conversion project. Converting a benchtop mill to cnc. I have a cnc4pc c10 breakout board.

i do not see on the c10 board where I can wire in limit switches. I am not an expert in electronics. Can the limit switch be wired directly to parallel port pins?

does anyone have a good diagram of how limit switch should be wired?

Thanks in advance.

homer
Re: need help with c10 board and mach 3
« Reply #1 on: May 27, 2012, 08:31:32 PM »
 :)
This .... from the CNC4PC site.