Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: homer897 on May 27, 2012, 08:10:15 PM
-
I am working on a new conversion project. Converting a benchtop mill to cnc. I have a cnc4pc c10 breakout board.
i do not see on the c10 board where I can wire in limit switches. I am not an expert in electronics. Can the limit switch be wired directly to parallel port pins?
does anyone have a good diagram of how limit switch should be wired?
Thanks in advance.
homer
-
:)
This .... from the CNC4PC site.