Hello Guest it is March 28, 2024, 05:46:52 AM

Author Topic: Tiny computer for MACH  (Read 19220 times)

0 Members and 1 Guest are viewing this topic.

Re: Tiny computer for MACH
« Reply #10 on: June 03, 2012, 10:13:33 PM »
Hi Vince,

we will make special cable connect to that RED connector to as 2nd LPT port.

OK, what does GPIO stand for and what would plug into it for a 2nd parallel port?

Vince

Offline olf20

*
  •  325 325
    • View Profile
Re: Tiny computer for MACH
« Reply #11 on: March 08, 2013, 03:24:11 PM »
Hi Vince, what Hz will this run Mach at??
Thanks
olf20 / Bob
Mach3, Atlas Knee Mill, 4th Axis, VcarvePro, ESS, Super PID.
Been Heating with corn since 1998