Machsupport Forum
Third party software and hardware support forums. => Promote and discuss your product => Topic started by: anthony_lu on May 23, 2012, 02:04:58 AM
-
The tiny embedded computer (1x Printer port and GPIO) special for CNC,
support Windows XP and MACH 3
NCBox-189 that comes with 1 GHz CPU, 1GB RAM, CF slot (bootable), 3 x USB, LAN, VGA, PS/2, LPT port and additional GPIO, 5V to 24V
size : 115 x 115 x 35 mm (palm size)
(http://www.roboard.com/temp/ncbox/NCBox-top.JPG)
(http://www.roboard.com/temp/ncbox/NCBox-bot.JPG)
(http://www.roboard.com/temp/ncbox/mach3.JPG)
see demo video http://www.youtube.com/watch?v=y62wvJkrIag
thanks
Anthony Lu (Taipei, Taiwan)
-
How much and can you make it with two parallel ports?
Vince
-
the retail price will be around USD 250.00 and there is 2 LPT come with, one is physical LPT port and 2nd can use GPIO port as red connector.
-
does that price come with windows XP?
Steve
-
no any O/S pre-install, it is regular PC standard, easy to install Windows or Linux
-
Is there an option for a faster CPU? I
Steve
-
What is a GPIO port and a red connector?
Vince
the retail price will be around USD 250.00 and there is 2 LPT come with, one is physical LPT port and 2nd can use GPIO port as red connector.
-
the CPU is embedded to avoid viberation , there is no chance to replace faster CPU
Is there an option for a faster CPU? I
Steve
-
thered connector is GPIO port can be use as 2nd LPT port (port 378)
What is a GPIO port and a red connector?
Vince
the retail price will be around USD 250.00 and there is 2 LPT come with, one is physical LPT port and 2nd can use GPIO port as red connector.
-
OK, what does GPIO stand for and what would plug into it for a 2nd parallel port?
Vince
-
Hi Vince,
we will make special cable connect to that RED connector to as 2nd LPT port.
OK, what does GPIO stand for and what would plug into it for a 2nd parallel port?
Vince
-
Hi Vince, what Hz will this run Mach at??
Thanks
olf20 / Bob