Hi this is my first post in this forum. Have a lot to lern.
Usialy when a for example a command M6 T002 is reached the spindle stops and I change the tool, set the hight and get on with the job.
Unfortunatly I updated mach3 and started using cambam at the same time so dont know which is the problem.
I copyed the Mach3Mill.xml over and all works well. exept one thing.
I am having a problem then the T (tool change) command in G code (I think)
after changing the tool, setting the hight,and pressing cycle start, Z goes up to +50 DROPPS the feed to 5 then VERY slowly back to Z0 once it gets back to Z0 the feed rate returns back to what ever it was before.
I dont understand why it is dropping to 5 but it is very anoying.
Any advice please?
Thank you