Evidently, it's got a DMC2132 controller card in it. I got it to talk to the slides finally yesterday, but I'm confused one the whole ports & pins configuration page. I downloaded the "User manual" from the Galil website and for the most part, understood everything that it was asking me to do to configure the motors and whatnot. I am just a little confused though in the "Limit \ Home" tab. It shows that All the axis use Port #1 and then it shows what pin #'s to use. Well, on the Mach3 page where you configure that, at the bottom it says that only pin#'s 10,11,12,13 & 15 can be used. If that's the case, then why does the manual tell me to use other ones? There's also a few other things in the same tab I don't understand, but I just want to clarify them one at a time. Any advice or help would be great appreciated.
You all have already helped me out a ton! :-)