Hello Guest it is January 20, 2020, 12:33:14 PM

Author Topic: New to CNC  (Read 1940 times)

0 Members and 1 Guest are viewing this topic.

New to CNC
« on: April 05, 2012, 02:12:18 PM »
I am new to CNC and Mach3. I just purchased router/engraver machine (TS-30408-H80). Neat machine but instruction manual is in Chinese. So I thought it might be easier to ask the forum a question than to learn Chinese.
 I cannot switch of emergency mode with reset button and cannot setup home/limit switches (machine doe snot have external/hard switches).
Can someone help please? 

Offline RonC

*
  •  32 32
    • View Profile
Re: New to CNC
« Reply #1 on: May 09, 2012, 06:51:14 AM »
Hi,
I am assuming that your machine does not have an actual E stop switch, go to Config, Ports & Pins, Input signals and scroll down to Estop then tick active low,
save and exit, should do it.
Cheers
RonC