Machsupport Forum
Mach Discussion => FAQs => Topic started by: holic46 on April 05, 2012, 02:12:18 PM
-
I am new to CNC and Mach3. I just purchased router/engraver machine (TS-30408-H80). Neat machine but instruction manual is in Chinese. So I thought it might be easier to ask the forum a question than to learn Chinese.
I cannot switch of emergency mode with reset button and cannot setup home/limit switches (machine doe snot have external/hard switches).
Can someone help please?
-
Hi,
I am assuming that your machine does not have an actual E stop switch, go to Config, Ports & Pins, Input signals and scroll down to Estop then tick active low,
save and exit, should do it.
Cheers
RonC