Here's the Touch Screen

Computer with spare power supply.  Gonna stick that inside the control.

Breakout board, Pixies & spindle board.  Those 3 grey wires are the leads from X,Y,Z encoders.  Sure wish I knew how to hook up all those pretty wires on the end of those leads.

'Nother shot of the boards

Getting stuff from outside to inside.

Looking good, looking good. 

Brett

I notice that all the jpg's in this thread are 0 kb.  I understand that there is a 4 pic limit per post.  If there is a limit about total pics I was not aware and apologize.

Ashby

Edit: 3/24  Fixed that.  Put 'em back.

I also wondered what I did?

My post are gone.

Darek

The problem is that we moved to a new server and in the move lost 2days of post The good new is that we only lost 2 days!The hits per hour got us kicked of the other server and we are now at a place that we can buy the server and do anythiing we like! So this will be the last time we have this problem...

Sorry and we are working on fixing it
Brian

Brian, Thanks for the heads up.

I was worried that I had been a bad boy.  Well I am bad, but that's a different story.

DAREK

My Pixie 100's want to send, enable, ref+ and ref-.

>>IF <<this is where those signals go it would be nice if the pretty green wire was enable and the other two were plus or minus.
I've been looking at the drawings 'till I'm cross eyed, I can find those three, but I can't figure which is which.

Ashby