Hello Guest it is March 29, 2024, 10:27:15 AM

Author Topic: machining stone jewellery  (Read 2245 times)

0 Members and 1 Guest are viewing this topic.

Offline stirling

*
  • *
  •  2,188 2,188
  • UK
    • View Profile
    • www.razordance.co.uk
machining stone jewellery
« on: February 14, 2012, 06:33:30 AM »
I'm looking for a "micro" mill of some description for machining and engraving slate jewellery. I know zilch about cutting stone but I'm assuming you end up with a lot of stone/water slurry that would eat bearings/screws for breakfast.

A machine sourcable in the UK would be a plus.

If you do/have done this - advice would be good.

Thanks

Ian
Re: machining stone jewellery
« Reply #1 on: February 14, 2012, 06:47:25 AM »
You might want to go check out these guys, they are a wealth of information on equipment and jewelry making

http://3dcadjewelry.com/forum/

Offline stirling

*
  • *
  •  2,188 2,188
  • UK
    • View Profile
    • www.razordance.co.uk
Re: machining stone jewellery
« Reply #2 on: February 15, 2012, 04:16:44 AM »
Thanks - I'll take a look.

Ian