Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: stirling on February 14, 2012, 06:33:30 AM
-
I'm looking for a "micro" mill of some description for machining and engraving slate jewellery. I know zilch about cutting stone but I'm assuming you end up with a lot of stone/water slurry that would eat bearings/screws for breakfast.
A machine sourcable in the UK would be a plus.
If you do/have done this - advice would be good.
Thanks
Ian
-
You might want to go check out these guys, they are a wealth of information on equipment and jewelry making
http://3dcadjewelry.com/forum/
-
Thanks - I'll take a look.
Ian