i was hoping he would run over this

it seems that dolphin will make good code for turning a profile.....

well, it looks like dolphin wont print anything usefull. bummer

Licensed of course ?
That looks like the kind of garble the pirates put out.

ya, me and rodney go way back. lol
see anything worth changing on my configs?

Hood will be along, I'm certain.
Might be working for the TAX man today.

I would suspect the problem is in the Dolphin config. as the code is goofy before it even gets to Mach.
Your screen shot looks oK to me.
Not much I can do with Demo, dang ! Wish I could help.

Russ

nothing is more frustrating than this. lol

There are two Dolphin PP for Mach, one for radius and another for diameter.
Which one are you using?

RICH

Hi Rich, till he gets back. Would it make any difference between the 2 pp's if he were just drilling on the cl ?
Do you use Dolphin, licensed ? What do you think of it ? I like the looks of the demo.
Thanks,
Russ

toubothis attached file and see if it does anything what you want
I didn't do anything special, just used you file and posted using the diameter mode PP.  

RICH