Hello Guest it is April 19, 2024, 09:39:14 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Upgraded to new hardware, Turn won,t run  (Read 2076 times)

0 Members and 1 Guest are viewing this topic.

Offline milehigh51

*
  • 13 13
    • View Profile
Upgraded to new hardware, Turn won,t run
« on: January 15, 2012, 11:53:43 PM »
Hi All
I upgraded to new hardware MB AMD 145 Single core processor.
When I load Mach3 Turn it locks up the CPU. Mach3 mill loads fine.
I have tried several versions of mach with the same results
Thank You

Roy
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Upgraded to new hardware, Turn won,t run
« Reply #1 on: January 16, 2012, 03:05:32 AM »
Do you have any brains or a macropump or any plugins in Turn that you dont in mill? Do you have a high kernel chosen in Turn?
If you attach your xml I will have a look and see if I can spot any issues.
Hood
Logged

Offline milehigh51

*
  • 13 13
    • View Profile
Re: Upgraded to new hardware, Turn won,t run
« Reply #2 on: January 17, 2012, 09:15:14 PM »
Hi Hood

Thanks for the reply.  I did find the problem.  In the bios disabled the following
secure virtual machine
power now
acpi srat table
C1E

This mother board is a Biostar  AMD 3 chip set.
I hope this may help someone else.

Roy
Logged
Pages: 1   Go Up
« previous next »