Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: milehigh51 on January 15, 2012, 11:53:43 PM
-
Hi All
I upgraded to new hardware MB AMD 145 Single core processor.
When I load Mach3 Turn it locks up the CPU. Mach3 mill loads fine.
I have tried several versions of mach with the same results
Thank You
Roy
-
Do you have any brains or a macropump or any plugins in Turn that you dont in mill? Do you have a high kernel chosen in Turn?
If you attach your xml I will have a look and see if I can spot any issues.
Hood
-
Hi Hood
Thanks for the reply. I did find the problem. In the bios disabled the following
secure virtual machine
power now
acpi srat table
C1E
This mother board is a Biostar AMD 3 chip set.
I hope this may help someone else.
Roy