Hello Guest it is March 28, 2024, 09:51:32 AM

Author Topic: Toonewbie or not toonewbie  (Read 2535 times)

0 Members and 1 Guest are viewing this topic.

Toonewbie or not toonewbie
« on: November 27, 2011, 07:57:27 PM »
I have Mach3 loaded on my Windows 7 machine and on my P4.  When I run on my 7 machine, I can run in live mode which is uselss as it does not have a parallel port.  I can't seem to run in live mode at all on my p4.   

I am trying to measure signal changes on some pins but can't get output. Any ideas.

thanks
Re: Reset
« Reply #1 on: November 27, 2011, 08:24:45 PM »
To me clearer.

I can't reset E-Stop unless I switch to offline.

Offline Chaoticone

*
  • *
  •  5,624 5,624
  • Precision Chaos
    • View Profile
Re: Toonewbie or not toonewbie
« Reply #2 on: November 27, 2011, 09:16:36 PM »
Sounds like your estop input is set to opposite of what it should be in config, ports and pins, inputs.

Brett
;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!
Re: Toonewbie or not toonewbie
« Reply #3 on: November 27, 2011, 11:01:51 PM »
I found a poster who had a similar problem with the newest version so I tried an older version and it seems to work for me on my 30 dollar Kijiji Pentium 4.