Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: blue_hound on November 27, 2011, 07:57:27 PM
-
I have Mach3 loaded on my Windows 7 machine and on my P4. When I run on my 7 machine, I can run in live mode which is uselss as it does not have a parallel port. I can't seem to run in live mode at all on my p4.
I am trying to measure signal changes on some pins but can't get output. Any ideas.
thanks
-
To me clearer.
I can't reset E-Stop unless I switch to offline.
-
Sounds like your estop input is set to opposite of what it should be in config, ports and pins, inputs.
Brett
-
I found a poster who had a similar problem with the newest version so I tried an older version and it seems to work for me on my 30 dollar Kijiji Pentium 4.