Hello Guest it is April 16, 2024, 04:32:17 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: How do you change Programs in MACH 3 File Menu  (Read 2987 times)

0 Members and 1 Guest are viewing this topic.

Offline hacker77

*
  • 34 34
    • View Profile
How do you change Programs in MACH 3 File Menu
« on: October 25, 2011, 12:38:16 PM »
Ok this has probably been answered a million times ,but here goes.  When opening Mach 3 and scrolling over "File" a list of programs appear,  (Sheetcam,V Carve Pro,Lazycam, etc.)  How does one ADD or REMOVE the programs in this list?     Thanks   Rich
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: How do you change Programs in MACH 3 File Menu
« Reply #1 on: October 25, 2011, 03:07:53 PM »
Uninstall the programmes in question I would think.
Hood
Logged

Offline hacker77

*
  • 34 34
    • View Profile
Re: How do you change Programs in MACH 3 File Menu
« Reply #2 on: October 26, 2011, 08:26:47 AM »
Thanks, Hood I try that and they stayed .I thought it might be customized to your taste.
Thanks Rich
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: How do you change Programs in MACH 3 File Menu
« Reply #3 on: October 26, 2011, 08:55:44 AM »
Dont know then probably have to email support and see if they can give you a clue how to do it, may mean editing the registry.
Hood
Logged

Offline RICH

*
  • *
  • 7,427 7,427
    • View Profile
Re: How do you change Programs in MACH 3 File Menu
« Reply #4 on: October 30, 2011, 06:30:25 AM »
I installed a trial copy of Sheetcam TNG and it created a listing under the file tab.
Once the program was uninstalled the Mach listing went away.
So uninstall the programs like Hood said and their listings should go away.

RICH
Logged
Pages: 1   Go Up
« previous next »