Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: hacker77 on October 25, 2011, 12:38:16 PM
-
Ok this has probably been answered a million times ,but here goes. When opening Mach 3 and scrolling over "File" a list of programs appear, (Sheetcam,V Carve Pro,Lazycam, etc.) How does one ADD or REMOVE the programs in this list? Thanks Rich
-
Uninstall the programmes in question I would think.
Hood
-
Thanks, Hood I try that and they stayed .I thought it might be customized to your taste.
Thanks Rich
-
Dont know then probably have to email support and see if they can give you a clue how to do it, may mean editing the registry.
Hood
-
I installed a trial copy of Sheetcam TNG and it created a listing under the file tab.
Once the program was uninstalled the Mach listing went away.
So uninstall the programs like Hood said and their listings should go away.
RICH