Hello all-
I connected my other computer and installed Mach 3 on it. I do not have my machine connected to the computer yet. I think it's mostly OK but when I load gcode it comes up in the window in a way that the font looks too tall and the bottoms of all the characters are cut off. I went to function config's, fonts, and found all were at 18pt Arial. I reset most of them to 12pt, and the problem returned as soon as I reloaded my gcode. They were the same (wrong) size. I went back to fonts, and they were all at 18pt Arial again. I tried this again with rebooting the whole system and the same problem occurred... Any suggestions? Thanks, Victor