ok simple one. I know I read this but I cant find it. when I open the editor and write a program. then save. when I return to the program run screen and try and load the file I just wrote i cant seem to find it. open the editor, Its right there. go back and try and load it. no dice. what format do i have to save it in, in order for Mach3 to see it.
 

Not sure what all you can save them in but I use the .tap file extension.

I've found that if you don't have a return (enter) after your last line that they don't show up sometimes, or at least the last line won't show.

Regards,

yeah Ive been through that. this is like some sort of format problem where when I try to load a saved program the mach software cant find it on my harddrive. even if I type the file name into the search prompt. I figured it out once but i cant figure out what I did.