Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: guynamedbathgate on December 16, 2006, 12:13:37 PM

Title: where are my programs?
Post by: guynamedbathgate on December 16, 2006, 12:13:37 PM

ok simple one. I know I read this but I cant find it. when I open the editor and write a program. then save. when I return to the program run screen and try and load the file I just wrote i cant seem to find it. open the editor, Its right there. go back and try and load it. no dice. what format do i have to save it in, in order for Mach3 to see it.
 :P

Title: Re: where are my programs?
Post by: Chaoticone on December 16, 2006, 12:34:30 PM

Not sure what all you can save them in but I use the .tap file extension.

Title: Re: where are my programs?
Post by: Scott on December 16, 2006, 01:45:31 PM

I've found that if you don't have a return (enter) after your last line that they don't show up sometimes, or at least the last line won't show.

Regards,

Title: Re: where are my programs?
Post by: guynamedbathgate on December 16, 2006, 02:38:22 PM

yeah Ive been through that. this is like some sort of format problem where when I try to load a saved program the mach software cant find it on my harddrive. even if I type the file name into the search prompt. I figured it out once but i cant figure out what I did.