I ran the post processor in sheetcam to make the .tap file. When I try to run it It tells me I have an error in line 11. Files that use to work for me before now error also. I have been beating myself up trying to figure out what is wrong without any luck. Hopefully someone here can tell me what I am doing wrong. I am using a diy plasma set up with mach 3. I had it cutting four months ago, and now it errors on me.

I believe the location that errors is G023

The post processor you used is for an ALLEN BRADELY controller pick one for MACH and it will run ok.

(;-) TP

ahhhh......I feel dumb now....haha