Hello Guest it is March 09, 2021, 05:53:21 AM

Author Topic: Digitizing with Mach3 Useing Microkinetics post processor  (Read 2506 times)

0 Members and 1 Guest are viewing this topic.

Digitizing with Mach3 Useing Microkinetics post processor
« on: September 02, 2011, 11:41:36 AM »
I'm new here looking for input on using Mach3 to digitize small ducts. Does anyone know if Mach3 will work with Microkinetics MN400 Drive Rack system, or a way to use Mach3 along side Microkinetics Millmaster/Multicam ?  Any input will be much appreciated-Mike

Offline RICH

*
  • *
  •  7,419 7,419
    • View Profile
Re: Digitizing with Mach3 Useing Microkinetics post processor
« Reply #1 on: September 04, 2011, 09:15:31 AM »
Not sure what your trying to accomplish. IE; Use Machs features to suplement code output lacking in the Microkinetics package or use Mach as the controlling program.

RICH
Re: Digitizing with Mach3 Useing Microkinetics post processor
« Reply #2 on: September 14, 2011, 01:40:59 PM »
I would prefer to use mach3 as controller rather than the Microkinetics which is lacking  many features in there digitizing abilities. thanks