Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: MTBBASSTIT on September 02, 2011, 11:41:36 AM
-
I'm new here looking for input on using Mach3 to digitize small ducts. Does anyone know if Mach3 will work with Microkinetics MN400 Drive Rack system, or a way to use Mach3 along side Microkinetics Millmaster/Multicam ? Any input will be much appreciated-Mike
-
Not sure what your trying to accomplish. IE; Use Machs features to suplement code output lacking in the Microkinetics package or use Mach as the controlling program.
RICH
-
I would prefer to use mach3 as controller rather than the Microkinetics which is lacking many features in there digitizing abilities. thanks