Hello Guest it is March 28, 2024, 08:53:20 PM

Author Topic: Change speed and zero fifth axis  (Read 3271 times)

0 Members and 1 Guest are viewing this topic.

Change speed and zero fifth axis
« on: December 13, 2006, 05:29:21 PM »

Friends:

I can not change the move speed by the F code and do not know how to zero the fifth axis.

A 5-axis CNC router is driven by Yaskawa servo motors and all axes are worked fine except the speed are too slow.

Thank you for any advice.

Eric Ma

Eric1ma@yahoo.com
Re: Change speed and zero fifth axis
« Reply #1 on: December 15, 2006, 08:03:45 AM »
You will need to aet up a 5axs screen set... check out the screen design section of the forum.

and the speed is a mix of Deg per min and In per min... If you look on the net there are a few places that talk about how to do that :( It is not a simple thing to do and most Cam systems should put out code to take care of that.

Thanks
Brian
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Re: Change speed and zero fifth axis
« Reply #2 on: December 15, 2006, 11:56:37 AM »
I will try the the 5th axis screen design
Thanks
Eric
Re: Change speed and zero fifth axis
« Reply #3 on: December 16, 2006, 04:43:30 PM »
Tell me if you have any trouble
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com