Hello Guest it is May 06, 2025, 01:20:45 AM
Profile Guest
« previous next »
Pages: « 1 2 3   Go Down

Author Topic: Radius to end of arc differs from radius to start on line number ##  (Read 35203 times)

0 Members and 1 Guest are viewing this topic.

Offline RICH

*
  • *
  • 7,427 7,427
Re: Radius to end of arc differs from radius to start on line number ##
« Reply #20 on: September 07, 2014, 07:57:55 PM »
Sunburned,
Your file backplots fine and Mach Mill runs it with no errors when I tried it out.

Post your xml file and someone will have a look.

RICH
Logged

Offline Sunburned

*
  • 5 5
Re: Radius to end of arc differs from radius to start on line number ##
« Reply #21 on: September 10, 2014, 07:19:34 PM »
Thanks for the help.  My XML is attached.  Please let me know if you need anything else.  I had to rename it so i could post it.
Logged

Offline Sunburned

*
  • 5 5
Re: Radius to end of arc differs from radius to start on line number ##
« Reply #22 on: September 12, 2014, 08:29:50 PM »
bump
Logged

Offline Sunburned

*
  • 5 5
Re: Radius to end of arc differs from radius to start on line number ##
« Reply #23 on: September 16, 2014, 09:39:14 PM »
Just wanted to check on this.  Any help would be great.

thanks
Logged

Offline RICH

*
  • *
  • 7,427 7,427
Re: Radius to end of arc differs from radius to start on line number ##
« Reply #24 on: September 17, 2014, 06:40:00 AM »
No errors reported here using your xml file.

RICH
Logged

Offline Sunburned

*
  • 5 5
Re: Radius to end of arc differs from radius to start on line number ##
« Reply #25 on: October 07, 2014, 01:47:38 PM »
I was hoping something would be found.  If anyone has any other ideas I would be happy to try them out.  Right now I have a very big and expensive paperweight.
Logged

Offline RICH

*
  • *
  • 7,427 7,427
Re: Radius to end of arc differs from radius to start on line number ##
« Reply #26 on: October 07, 2014, 04:59:15 PM »
Code works fine here. See pic ....

RICH
Logged

Offline stirling

*
  • *
  • 2,188 2,188
  • UK
    • www.razordance.co.uk
Re: Radius to end of arc differs from radius to start on line number ##
« Reply #27 on: October 08, 2014, 03:49:35 AM »
The file you posted in reply #21 is not an XML file. It's a copy of the program MachXML.exe. Please post your xml PROFILE file. That's the one ending in .xml in your Mach3 folder with the same name as the profile you're using.
Logged
Pages: « 1 2 3   Go Up
« previous next »