Hello Guest it is June 25, 2019, 12:34:56 AM

Author Topic: ActivateSignal(OUTPUT1)  (Read 4720 times)

0 Members and 1 Guest are viewing this topic.

ActivateSignal(OUTPUT1)
« on: December 12, 2006, 07:35:09 PM »
Hi All,

First post so I hope I'm in the right spot.

I'm in the rudimentary stages of setting up a G100 and wanted to write a few (what I thought would be) "simple" macros to control the outputs.

I first went into config/ports & pins/output signals and enabled output 1, 2, 3, and 4.  I set 1,2, and 3 active low, which on the G100, activates the LED's so I have 3 LED's on and 1 off.

I went to Notepad and put in the single line: ActivateSignal(OUTPUT1). I tried 2, 3 and 4 as well.  I saved it as M101.m1s. 

Needless to say, when run in Mach3, the G100 was unimpressed.  It sat there unblinking.  What am I missing??

Thanks,
Walt

Re: ActivateSignal(OUTPUT1)
« Reply #1 on: December 12, 2006, 10:55:26 PM »
I thought this macro was too simple for even me to get wrong.
I had it in the wrong directory.
I'll just slink away now............
Re: ActivateSignal(OUTPUT1)
« Reply #2 on: December 15, 2006, 08:07:00 AM »
No problem! Nice to see that you fixed it  8)
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com