Hello Guest it is May 06, 2025, 01:55:22 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: how turn off the plasma air at the end of cut?  (Read 4652 times)

0 Members and 1 Guest are viewing this topic.

Offline Johnny Storm

*
  • 163 163
how turn off the plasma air at the end of cut?
« on: August 02, 2011, 10:57:04 PM »
I have a cnc plasma table with a hypertherm powermax 65, there is a way to turn off the air at the end of the cut? i know this air is for cooling the nozzle but at the end of the cut i think is not necesary
Logged

Offline BR549

*
  • 6,965 6,965
Re: how turn off the plasma air at the end of cut?
« Reply #1 on: August 03, 2011, 12:06:50 AM »
The air flow control is part of the plasma unit. It needs to cycle when IT needs it.

(;-) TP
Logged

Offline Johnny Storm

*
  • 163 163
Re: how turn off the plasma air at the end of cut?
« Reply #2 on: August 03, 2011, 12:15:16 AM »
yes but at the end of every work y have to pull the triger fast and release of the plasma gun for turn off the air, i have a manual torch, i try adding at the end of the g code an comand to turn on and off the torch for turn off te air but dont work
Logged

Offline BR549

*
  • 6,965 6,965
Re: how turn off the plasma air at the end of cut?
« Reply #3 on: August 03, 2011, 12:44:47 AM »
It would seem that you did not get the torch functions interfaced to the controller properly.

(;-) TP
Logged
Pages: 1   Go Up
« previous next »