Hello Guest it is March 28, 2024, 01:56:39 PM

Author Topic: how to setup motor parameter in Mach3 when I use service motor  (Read 2741 times)

0 Members and 1 Guest are viewing this topic.

as the topic :

thank you!

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: how to setup motor parameter in Mach3 when I use service motor
« Reply #1 on: July 02, 2011, 04:46:27 AM »
If you are meaning servo motor then it is the encoder count you use for the steps per unit calculation.
Would need a lot more info to say more.
Hood
Re: how to setup motor parameter in Mach3 when I use service motor
« Reply #2 on: July 03, 2011, 08:27:52 PM »
ok thank you
I want to know how to setup servo motor ,step by step, because I am a new user for mach3

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: how to setup motor parameter in Mach3 when I use service motor
« Reply #3 on: July 07, 2011, 07:16:14 AM »
You will have to give a lot more info for any help to be given.
Do your drives accept Step/Dir input?
 What line encoder do you have?
What RPM is the motor rated at?
 Any gearing between motor and screw?
Any electronic gearing in your drives?
What pitch of ballscrew?

Hood