I have searched the forum and it doesn't look like anyone is using camworks.
we are using solidworks 2011 with camworks 2011 and a Mikini 1610L mill running Mach 3.
Does anyone have a post that works?
Our VAR has so far been unable to get us something that works.

I've had the most problems anytime a g41 is output. Everything steps through fine, but Mach will run completely erratic with some moves even going backwards.

Any help is appreciated.

Any of the early Fanuc posts should get you started. Camworks should be able to provide you with a proper post.

(;-) TP