Hello Guest it is April 18, 2024, 03:34:09 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Waterjet CV  (Read 2802 times)

0 Members and 1 Guest are viewing this topic.

Offline machfab

*
  • 17 17
    • View Profile
Waterjet CV
« on: May 19, 2011, 09:43:56 AM »
What should the CV settings be for a waterjet machine?
Logged

Offline knorton44

*
  • 2 2
    • View Profile
Re: Waterjet CV
« Reply #1 on: May 20, 2011, 09:12:00 AM »
If your cutting really thin stuff at high speeds use "exact stop" to prevent corner rounding.
I use "CV" for all the rest.
 Jay
Logged

Offline machfab

*
  • 17 17
    • View Profile
Re: Waterjet CV
« Reply #2 on: May 20, 2011, 09:51:18 AM »
Do you have to call up cv mode from the g-code or is it on all the time?
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Waterjet CV
« Reply #3 on: May 20, 2011, 02:24:21 PM »
CV mode is set on General Config page but can be overridden by code. If your code has G64 in it then that is CV mode, if your code has G61 then it will be Exact Stop. You can obviously change at will during a run of code by having G61 or G64 in your code at the relevant points.
Hood
Logged
Pages: 1   Go Up
« previous next »