Hello Guest it is November 20, 2019, 06:28:37 AM

Author Topic: limit swithces, dont work  (Read 2242 times)

0 Members and 1 Guest are viewing this topic.

limit swithces, dont work
« on: April 22, 2011, 05:08:23 PM »
Hi, I'm trying to set the limits of my machine race.
 install the switches, but when the switch is alcnazado by a shaft, a message that says Linit tiggered switch, and the only way to move the axis is reset.
 not supposed to trigger the switch when the shaft may run in the opposite direction?
 I hope I can helpthanks
 ???

Offline Tweakie.CNC

*
  • *
  •  8,005 8,005
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: limit swithces, dont work
« Reply #1 on: April 23, 2011, 08:31:38 AM »
Could well be switch "bounce". Try increasing the debounce interval on the general config page  ( 500 to 1000 perhaps ).

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.