Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: diegone on April 22, 2011, 05:08:23 PM

Title: limit swithces, dont work
Post by: diegone on April 22, 2011, 05:08:23 PM

Hi, I'm trying to set the limits of my machine race.
 install the switches, but when the switch is alcnazado by a shaft, a message that says Linit tiggered switch, and the only way to move the axis is reset.
 not supposed to trigger the switch when the shaft may run in the opposite direction?
 I hope I can helpthanks
 ???

Title: Re: limit swithces, dont work
Post by: Tweakie.CNC on April 23, 2011, 08:31:38 AM

Could well be switch "bounce". Try increasing the debounce interval on the general config page  ( 500 to 1000 perhaps ).

Tweakie.