Hello Guest it is August 11, 2020, 11:56:12 PM

Author Topic: New Pokeys 56 Modbus config with MACH  (Read 9188 times)

0 Members and 1 Guest are viewing this topic.

Offline borisz

*
  •  217 217
    • View Profile
    • www.poscope.com
Re: New Pokeys 56 Modbus config with MACH
« Reply #10 on: April 30, 2011, 03:36:34 AM »
Hi!

In the next week new software and firmware will be avaiable which will fix that.

regards

Boris
www.poscope.com home of PoKeys USB HID, IO, USB, Ethernet controler and PoScope USB PC oscilloscope
Re: New Pokeys 56 Modbus config with MACH
« Reply #11 on: May 12, 2011, 02:09:57 AM »
Ok, new firmware installed, LEDs work OK. Has anyone done jogging in MACH3 with the PK? When I push a button it starts moving and it doesn't stop. I am sure this is something simple.
Re: New Pokeys 56 Modbus config with MACH
« Reply #12 on: May 15, 2011, 06:06:48 PM »
I figured it out. I take a signal from the modbus and make it "jog X - right" for example. Then I take the same signal, invert it and terminate it with a "JOG Off X" button. 

So more or less I have done everything I need, it's time to put all the switches and pots in some enclosure and test it real world cutting.