Yes!
I know that the axis do what the code says and it is similar to the convention. I wrote you with pics in Mail.
But if i change the the Port and pin config, only the axis dir change, not the displayed toolpath!!! The axis rotation is correct with RC Code, the RC Sim and the conventions!!
now. all the ,,Problem,, is the reverse toolpath shown in Mach. the axis rotary it´s ok.
Ger. I changed and play with all the values (port and pins) in config !!!! I will get not any other constellation,
BR. try to put the code to mach and play with Port and pins, so you will see that only the turn dir change, not the path dir on Mach!
For the next example, if Mach accept all written code, it will be the same if have negative or positive values. the Toolpath have to follow in same dir.
RC give out everytime negative A Values in Standard Mill Operations (not indexing) and rotade cw!!! That is fixed in RC and is right to the conventions!!! I can´t change, cause i t is programmed and normal in RC !!!! Also i can´t edit the whole Code, cause by example my turbo wheel have more than 2000 lines with A values!!
By the way, a lot of People use RC with MAch.
BR. What do you think about axis way´s and tool way´s?
??
I try to explain, if the tool is fixed ( Z) ,....and the axis rotate cw, shows the moving tool ccw on a fixed axis.!!!!! Thats what Mach shows.
could it be the solution?
BR Rudi