Hello Guest it is June 20, 2019, 12:04:36 AM

Author Topic: How do I repeat the cut of the same part?  (Read 5315 times)

0 Members and 1 Guest are viewing this topic.

Re: How do I repeat the cut of the same part?
« Reply #10 on: March 15, 2011, 11:26:20 AM »
I am really impressed now that I learned about the enter key.  I used the multipass wizard to cut the Z depth in steps and then used the nesting wizard to repeat the part over the material size.

Steve.
Re: How do I repeat the cut of the same part?
« Reply #11 on: March 15, 2011, 03:16:49 PM »
I've only been using Mach for about 3 or 4 years.....

where is the nesting wizard? :-[ :-[ :-[ :-[

ATB
Derek :-[
You can "chop it off" but can't "chop it on"
Re: How do I repeat the cut of the same part?
« Reply #12 on: March 15, 2011, 03:21:24 PM »
 :)
Re: How do I repeat the cut of the same part?
« Reply #13 on: March 15, 2011, 03:28:22 PM »
Jeez !

I've been down that list about a billion times !
Normally straight to the Write text wizard.

Well at least thats my "dumb question of the week" out of the way LOL


:)
You can "chop it off" but can't "chop it on"
Re: How do I repeat the cut of the same part?
« Reply #14 on: March 15, 2011, 03:44:09 PM »
I've been down that list about a billion times !
:D
Me too ... and still finding something new there on occasion. ;D
Re: How do I repeat the cut of the same part?
« Reply #15 on: March 21, 2011, 12:18:40 AM »
You can also use G52 to offset the axis you want.
G52 X5Y5 creates an offset in the x and y of 5 inches(in inch mode).
You must remember to cancel any such offset with a G52 X0Y0Z0 or call out the new desired offset.

This is probably well known, but I was happy to find it a while back and it has come in handy.

Frank