Hello Guest it is March 29, 2024, 09:00:48 AM

Poll

Is there a basic tutorial how to config mach3 to run 5 steper motors?

I dont understand
0 (0%)
what this mean, sorry
0 (0%)

Total Members Voted: 0

Author Topic: my 5 step motors acting strangely  (Read 22450 times)

0 Members and 1 Guest are viewing this topic.

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: my 5 step motors acting strangely
« Reply #40 on: March 02, 2011, 05:53:49 PM »
And motor tuning the same?
Try swapping the X and Y motors around and see if the problem follows the motor.
Hood
Re: my 5 step motors acting strangely
« Reply #41 on: March 02, 2011, 05:58:24 PM »
Well the problem didnt follow the motor
Re: my 5 step motors acting strangely
« Reply #42 on: March 02, 2011, 05:59:00 PM »
And the motor tuning are the same

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: my 5 step motors acting strangely
« Reply #43 on: March 02, 2011, 06:02:24 PM »
Ok next go into Ports and Pins Motor  setup and change the Step and Dir for X axis to 1 and 17 and then change Y to 16 and 14 and see if when you press the X jog keys if the motor is good, same for other motor when you press Y jog
Hood
Re: my 5 step motors acting strangely
« Reply #44 on: March 02, 2011, 06:05:21 PM »
Yes now the problem moved from the Y axis to the X axis

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: my 5 step motors acting strangely
« Reply #45 on: March 02, 2011, 06:08:00 PM »
Ok so if you unplug the parallel cable and attach your remote control does the Y axis move smooth?
Hood
Re: my 5 step motors acting strangely
« Reply #46 on: March 02, 2011, 06:10:30 PM »
Yes than it works moths
Re: my 5 step motors acting strangely
« Reply #47 on: March 02, 2011, 06:12:31 PM »
I mean it works smooth with the remoter

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: my 5 step motors acting strangely
« Reply #48 on: March 02, 2011, 06:13:00 PM »
Ok it would seem its a parallel port or Mach problem. I dont see anything wrong in your config so I would guess at a bad port or bad cable, most likely the cable.
Hood
Re: my 5 step motors acting strangely
« Reply #49 on: March 02, 2011, 06:15:43 PM »
OK, can I try the port with the test software and see if that gives me any information?